Cold Galve Zinc Rich Primer Ultra High Anti Corrosion Metal Primer
- Application By Brush Roller & Suitable Spray
- Fast Dry Time In as Little as 2-4 Hours Touch Dry
- High Chemical & Anti corrosion Protective Coating for Metal
- Sacrificial Primer Coating
- Multi-Buy Discounts
- Free Delivery Available
- Regular price
- £64.99 Inc. VAT
- Sale price
- £64.99
- Regular price
-
- Unit price
- per
Description
Cold Galve Zinc Rich Primer (Europrime 2 Zinc Rich) 90% Zinc Content in the DFT, offering enhanced anti corrosive properties for mild steel.
For the best performance Zinc Rich primers should be over coated with a suitable topcoat. It can be left uncoated but will eventually allow moisture to breach the film.
(Please note this product will be supplied with a small hole in the lid covered with tape this is to stop the lid being blown off due to pressure build up)
Key Facts
Can be brushed, rolled or spray applied Touch Dry 2-4 hours
Over coat 12-24 hours
Thinners suitable T0001 White Spirit Covers Approx. 8 square metres per litre (this does not account for the method of application, absorption of substrate or wastage)
Application - Painting over existing paint
Step 1 - Check suitability of the product to the existing paint. We recommend you try a sample area first.
Step 2 Clean and Abrade -
- Make sure the existing paint is in good condition prior to painting, then lightly abrade to provide a key for good intercoat adhesion.
- If there is flaking paint this must be removed prior to painting.
- For any parts that has rusted you will need to sand the rust back to the bare metal
- Ensure substrate is clean of any dirt, oil, or grease
Step 3 Primer - Apply primer
Step 3 Topcoat- Once you have completed the following steps you can apply your top coat.
Other Primers
Mild Steel – If you are painting mild steel you will need our Metal Primer to view this please Click here
Fibreglass – If the fibreglass is bare you will need a fiberglass primer. For Two Pack Epoxy Fiberglass Primer Click here. For Single Pack Fiberglass Primer Click here
Galvanised Steel – Once you have treated the galvanised steel with Mordant Solution (T-Wash) you will need our Metal Primer. Click here
Etch Primer – For One Pack Etch Primer. Click here
Aluminium – The primer suitable for aluminium is Two Pack Etch Primer. Click here
Wood, Concrete, Stone or Brick - No primer requiored 1st coat will prime and seal. You will find that these kind of substrates will be porous, we recommend that on your first coat thin by 20% to ensure it impregnates the substrate. Then after 12-24 hours apply the second coat un thinned.
Always stir paint well prior to using
Make sure you use a broom stick, mixer on a slow running drill or pallet knife to mix and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.
As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.
Calculate Your Solvent Paint
Total Sqm:
Quantity Needed:
Quantities are approximates per coat, we cannot allow for wastage and or any absorption that may occur with porous substrates.
Total Sqf:
Quantity Needed:
Quantities are approximates per coat, we cannot allow for wastage and or any absorption that may occur with porous substrates.